Balanced thd

Marchio: Audiophony Categoria: Microfoni per Installazioni 1 mic input via XLR3-F on front panel 1 RJ45 output on rear panel Talk button on front panel to active the microphone Chime button on front panel to activate the chime Volume setting (mic and chime) on rear panel Lock/unlock switch to lock zone selection Output level displayWith LEDs Powered by an RJ45 cable from the PREZONE88 Input sensitivity: -60 dB ± 3 dB / 600Ω balanced THD: less than 0.1% Frequency response: 45 Hz ~ 15 kHz Signal-to-noise ratio: less than 90 dB Output level: 0 dB / 600Ω Weight: 0.9 kg Dimensions: 140 x 60 x 205 mm

Marchio: Audiophony Categoria: Finali di potenza Class-D amplifier Switched-mode power supply Mode selection: Stereo, Bridge or Parallel Independent limiter for each channel Extremely accurate and independent level settings for each channel LEDs indicators Convection cooled Balanced Jack TRS and XLR inputs Unbalanced RCA outputs Binding post-jacks or speakON outputs Short-circuit, over current and high temperature independent protections for each channel 2x19" rack mount spaces Stereo Max power: 4 Ω RMS stereo power (minimum): 2 x 150 W RMS; 8 Ω RMS stereo power: 2 x 80 W RMS Mono bridged Max power: 8 Ω bridged power (minimum): 1 x 300 W RMS Signal-to-noise ratio Less than 90 dB Input sensitivity: 4 dBu +/-2 dB Distortion: THD at 1 kHz 1/2 rated power Less than 0.1%; Slew rate: - 65 dB at 1 kHz; Frequency response (4 Ω/1 W): +0.5 dB; 20 Hz-20 kHz Input impedance: unbalanced 15 kΩ / Balance 30 kΩ Clip: 0 dBr Cooling: Convection cooled Input connectors: XLR3-F, Balanced 6.35 mm TRS-F jack + Unbalanced RCA Output connectors: Binding post-jacks + 4-pole speakON® Front control panel: AC power switch, Channel 1 and 2Volume Rear control panel: Mode selection button Indicators: Protect (red) / Clip (yellow) / Signal (green) Protections: Short-circuits, over current and high temperature protected Power supply: 100/230 V AC - 50/60 Hz Dimensions: 482 mm x 44 mm x 330 mm NetWeight: 4.3 kg

LD SYSTEM MEI 100 EAR MONITOR: Praticamente NUOVO, utilizzato 2 volte, vendesi per inutilizzo. Specifications MEI 100 BPR Receiver: Article No.: LDMEI100BPR Frequency range: 838 MHz to 865 MHz Image rejection: > 60 dB S/N ratio: > 95 dB THD: 90 dB, A-weighted Dimensions: 95 mm x 65 mm x 25 mm Weight: 0.57 kg Power requirements: 2 AA batteries Battery life: > 8 hours (depending on battery type) Specifications MEI 100 T Transmitter: Article No.: LDMEI100T Frequency range: 838 MHz to 865 MHz RF output power: 10 dBm Gain adjustment range: 20 dB Max. audio input level: +12 dBV Front panel controls: Power, Set, Up and Down, Headphone volume control Rear panel controls: Input level left/right, Stereo/Mono switch Input: Neutrik COMBO balanced (left/right) Dimensions: 212 mm x 90 mm x 38 mm Weight: 0.85 kg Power requirements: 12 V to 18 V at 300 mA, supplied by external power supply

Amplificatore integrato stereofonico bilanciato Potenza per canale 180 watt su 8 ohm e 260 watt su 4 ohm Controllo volume aava (accuphase analog vari-gain amplifier) Sezioni pre e finale separate, con uscite pre out e ingressi main in bilanciati xlr e sbilanciati rca, sfruttabili anche individualmente mediante selettore sul pannello frontale Stadio d'amplificazione con tecnologia mcs+ e nuovi mos-fet di potenza certificati per altissime tensioni d'esercizio in tripla configurazione push-pull Stadio d'uscita current feedback con tecnologia balanced remote sensing a bassissima impedenza, con damping factor superiore a 600 Stadio d'alimentazione con trasformatore toroidale sovradimensionato e condensatori di filtro d'elevata capacita' Selezione segnali in ingresso mediante logic-controlled relays Circuito di protezione dei diffusori con semiconduttori mos-fet a bassissima resistenza Inedito circuito di protezione nello stadio di potenza dotato di fotoaccoppiatore e sensore di temperatura, in grado di rilevare in tempo reale eventuali sovraccorrenti e surriscaldamenti, arrestando istantaneamente l'erogazione di corrente Controllo di toni escludibile, selezione di fase e bilanciamento canali Amplificatore per cuffie dedicato - peak power meter analogici Risposta in frequenza fino a 3 hz - 150 khz Distorsione armonica totale (thd) 0,05% da 4 a 16 ohm - Rapporto segnale/rumore (s/n ratio) fino a 125 db 2x ingressi bilanciati xlr, 5x ingressi sbilanciati rca, ingressi/uscite recorder Doppio set di terminali per diffusori 2 slot per schede accuphase opzionali (phono mc/mm, dac, linea) con impostazioni gestibili mediante appositi comandi gia' integrati sul frontale Telecomando in dotazione Dimensioni (l x a x p): 465 mm x 181 mm x 428 mm Peso: 24,6 kg LISTINO: 11000€ VALUTIAMO PERMUTE SPEDIZIONI IN TUTTO IL MONDO GARANZIA UFFICIALE ITALIANA Contatti cell.3283746218

Kit All-In-One, Ideale per leb'/xc2/xa0'registrazione studio e home. Rode Complete Studio Kit comprende: AI-1 Audiointerface, Rode NT1 Microphone, SMR Shockmount and XLR Cable b'/xc2/xa0'AI1: USB 2.0 Audiointerface; 24-Bit / 96 kHz. Gain-Switch with Signal-LED; switchable Direct-Monitoring of the recording signal; +48V Phantom Power switchable Connections: 1x Mic-/Instrument Combo Input XLR/Jack 6.3 mm, 2x Line-Out Jack 6.3 mm balanced, Stereo Headphone Out Jack 6.3 mm, USB-C; bus-powered; incl. USB-C/A-Cable. Dimensioni: 124 x 100 x 38 mm Peso: 560g NT1: Large diaphragm condenser microphone, 1b'"' capsule with cardioid pattern, internal capsule suspension, which employs patented Lyre technology from Rycote, 4.5dBA of self-noise, black housing with durable ceramic firearm coating baked onto the surface, includes SMR shockmount and detachabel stainless steel pop shield. Realizzato in Australia. Frequency range: 20 - 20000 Hz, impedance: 100 Ohms, sensitivity: 35,0 mV/Pa, max. output level: +8,0 dBu (1 kHz, 1% THD, 1 kOhm Last), dynamic range: 128 dB, max SPL: 132 dB, signal to noise: 90 dBA (IEC651), requires 24V/48V phantom power, 3-pin XLR connector, Ableton Live Lite DimensionI: 50 x 190 mm Peso: 395 g b'/xc2/xa0'

GOMono-F5 receiver 16 UHF frequenciess Frequency range: UHF 514~542 MHz (4G compatible) The Diversity system ensures a perfect reception Adjustable Squelch to absorb interferences You can use up to 4 receivers at the same time (4 mic) Adjustable antennas (front) Average range in perfect conditions: 70m Outputs: balanced XLR3-M and 6.35 mm TS-F unbalanced jack Use FREE-RACK to stack them in racks (optional) Dimensions: 130 x 36 x 92 mm GOBody-F5 transmitter Must be combinedWith a tie-clip or headband GO series microphone and a GO-MONO receiver High-quality electret microphone THD: b' Input: mini XLR3-F 2 sensitivity modes: line or micro OperatesWith 2x1.5V type AA batteries Must be combined With a tie-clip or headband GO series microphone and a GO-MONO receiver Dimensions: 237 x 58 mm GOHead headband microphone Headband microphone only. Must be combinedWith a GO-BODY transmitter and a GO-MONO receiver Mini XLR3-F connector SuppliedWith a microphoneWindshield and an adjustable headband Unidirectional electret Frequency response: 100 Hz at 16 kHz S/N: b'>' 60dB Impedance: 2.2 kohm