Response bandwidth

Prezzo ridotto da 129€ -> 69€ Tuner - Tuner Type Radio tuner - AM/FM - digital - Response Bandwidth 30 Hz - Signal-To-Noise Ratio 65 dB - Total Harmonic Distortion mono: 0.3%, stereo: 0.8% - Station Memo Display Yes - Timer sleep Amplifier - Output Power / Total 300 Watt - Input Impedance 47 KOhm - Input Sensitivity 200 mV Amplifier Output Details - Output Power / Channel 60 Watt - Output Impedance / Channel 8 Ohm - Frequency Response 40 - 20000 Hz - Total Harmonic Distortion (THD) 0.07 %, 0.09 % - Channel Type center, front, main, rear - Channel Qty 1, 2 Radio - Tuner Type digital - Tuner Bands AM/FM - Tuning Display fluorescent display - Preset Station Qty 30 - Auto Preset Memory - Antenna Form Factor loop AM / wire FM

Equalizzatore originale americano, 110 volt Frequency Response: 20Hz to 20,000Hz +/- 0.5dB Hum and Noise: 90dB (79uV) below 2.5V flat response. 85dB (140uV) below 2.5V worst case. Harmonic and Intermodulation Distortion: less than 0.02% at 2.5V output 20Hz to 20,000Hz Low frequency Compensation: Variable from 0 to +17dB at 20Hz Input Sensitivity: 2.5V into 27k ohms for rated output with controls set for flat response High Frequency Compensation: Variable +/-10dB at 20,000Hz Output Level and Impedance: 2.5V into 10k ohms or more with the output level at zero and all other controls set for flat response. Programmable Filters: 14 sections (7 per channel) each of which can be programmed for standard 1/3 octave center frequencies from 20Hz to 1000Hz. Filter bandwidth is programmable for narrow (approx. 1/3 octave) or wide (approx. 1 octave). Amplitude is continuously adjustable +/- 12dB for narrow and +/-15 dB for wide. A detented control is used to position for flat response. Programming is achieved by means of plug-in capacitors provided with the MQ107. Size: 3-1/2" high, 5-3/4" wide and 14" long Finish: Chrome and black Weight 7 lbs. 9 oz.

Vendo Amplificatore Car Stereo Harman Kardon CA 260 usato pochissimo. Caratteristiche Tecniche: Power Output, RMS 60 watts per channel into 4 Ohms, 20 - 20,000Hz: 90 watts per channel into 2 Ohms, 20 - 20.000Hz: 180 watts bridged mono into 4 Ohms, 20- 20,000Hz HCC (High Instantaneous Current. +/-30A Capability) THD (4 Ohms/2 Ohms): No more than 0.1 %10.2% Negative Feedback: 25dB Power Bandwidth. 10Hz to 100,000Hz Frequency Response 10Hz to 100,000Hz + 0, - 3dB Signal-to-Noise Ratio: 80dB lnput Sensitivity Line Level: 0.1V10.5V (switchable) High Level: 1V Active Crossover Characteristics High Pass. 200Hz, 12dB/Octave Low Pass: 200Hz, 6dB/Octave Power Supply. DC +13.8V (11 -16V usable), negative ground Typical lnput Current Requirements At Idle. 2.5A Full Power MUSIC Signal 6 7A (4 Ohms/ch.) 10A (2 Ohms/ch.) Full Power Sine Wave. 20A (4 Ohms/ch.) 30A (2 Ohms/ch.) Dimensions (W x H x D). 15-518" x 3-718'' x 7-1/8" (396 x 98 x 180mm) Weight. 1Olbs. 202. 14.6kgl