V connectors

Videoregistratore PHILIPS VR 730 - HiFiStereo - Turbo Drive â€â€Å“ 75s Rewind Time - Digital Studio Picture Control - Showview / VideoPlus + - Automatic Longplay Recording - NTSC Playback - Front A/V Connectors - Turbo Timer - Follow TV Eventuale spedizione: + 12,00 euro

Marchio: Rondson Categoria: Microfoni Senza Filo Palmari Four Channel Wireless Handheld Microphone System; PLL synthesizer; UHF Frequency Range: 669.1/655.0/676.6/663.0 MHz easy-to-read LCD displays; 50 mt. in open areas; Modulation Type: FM; Frequency Deviation: +/- 22 kHz; Frequency Response: 50-15.000 Hz; Frequency Stability: +/- 10 ppm; Interference Rate: b'>' 50dB; S/N Ratio: b'>' 90dB; Sensitivity: - 80 dBuV; Distortion: b' Output Impedance: 600 ohm; Audio Output Level: - 400 mV (balanced/unbalanced); Output connectors: 4x XLR-3M, 1x Jack TRS 6,3mm; Antenna connectors: 2x BNC; Receiver BE-1040: dimensions: 480x180x46 mm, weight: 3,5 kg, power: 110-240V / 12 V 1000 m A, consumption: b' Transmitters BE-1040MIC: dimensions: 240x50x33mm, RF Power: 10 mW, power supply: 2x 1,5V AA.

Marchio: Audiophony Categoria: Finali di potenza Class-D amplifier Switched-mode power supply Mode selection: Stereo, Bridge or Parallel Independent limiter for each channel Extremely accurate and independent level settings for each channel LEDs indicators Convection cooled Balanced Jack TRS and XLR inputs Unbalanced RCA outputs Binding post-jacks or speakON outputs Short-circuit, over current and high temperature independent protections for each channel 2x19" rack mount spaces Stereo Max power: 4 Ω RMS stereo power (minimum): 2 x 150 W RMS; 8 Ω RMS stereo power: 2 x 80 W RMS Mono bridged Max power: 8 Ω bridged power (minimum): 1 x 300 W RMS Signal-to-noise ratio Less than 90 dB Input sensitivity: 4 dBu +/-2 dB Distortion: THD at 1 kHz 1/2 rated power Less than 0.1%; Slew rate: - 65 dB at 1 kHz; Frequency response (4 Ω/1 W): +0.5 dB; 20 Hz-20 kHz Input impedance: unbalanced 15 kΩ / Balance 30 kΩ Clip: 0 dBr Cooling: Convection cooled Input connectors: XLR3-F, Balanced 6.35 mm TRS-F jack + Unbalanced RCA Output connectors: Binding post-jacks + 4-pole speakON® Front control panel: AC power switch, Channel 1 and 2Volume Rear control panel: Mode selection button Indicators: Protect (red) / Clip (yellow) / Signal (green) Protections: Short-circuits, over current and high temperature protected Power supply: 100/230 V AC - 50/60 Hz Dimensions: 482 mm x 44 mm x 330 mm NetWeight: 4.3 kg

Marchio: Rondson Categoria: Microfoni Senza Filo ad Archetto Four Channel Wireless Microphone System bodypack; BE-10HM: Lavalier microphone compatible with BE-10 and BE-20 sets; BE-10BP: Headset microphone compatible with BE-10 and BE-20 sets; PLL synthesizer; easy-to-read LCD displays; 50 mt. in open areas; Modulation Type: FM; Frequency Deviation: +/- 22 kHz; Frequency Response: 50-15.000 Hz; Frequency Stability: +/- 10 ppm; Interference Rate: b'>' 50dB; S/N Ratio: b'>' 90dB; Sensitivity: - 80 dBuV; Distortion: b' Output Impedance: 600 ohm; Audio Output Level: - 400 mV (balanced/unbalanced); Output connectors: 4x XLR-3M, 1x Jack TRS 6,3mm; Antenna connectors: 2x BNC; Receiver BE-1040: dimensions: 480x180x46 mm, weight: 3,5 kg, power supply: 110-240V / 12 V 1000 m A, consumption: b' Transmitters BE-1040BP: dimensions: 58x18x100mm, RF Power: 10 mW, power: 2x 1,5V AA.

Marchio: Audiophony Categoria: Casse da installazione Compact medium range coaxial system IP65 with a minimum downward inclination of 5°. Works with 100 V or 8 ohms Power: 400 W RMS – 800 W max. @ 8 ohms 75/150/300 W @ 100 V Woofer: 15" 3" coil Tweeter: 1 x 1.7" coil Dispersion: 80° x 80° (HxV) Frequency response: 50 ~ 18,000 Hz SPL: 129 dB continuous, 135 dB max. / 8 ohms Connectors: Internal terminal block with cable glands Aluminum grill, stainless steel screws Dimensions: 498 x 501 x 596 mm Net weight: 27.5 kg

1400W + 700W – 137DB SPL ACTIVE PRECISION COVERAGE VERTICAL ARRAY 2-way powered bi-amplified true line array, bass reflex design, internal Digital Signal Processor 1400Wrms LF and 700Wrms HF Class D (PWM) high efficiency integrated amplifier 8 woofer custom al neodimio da 200mm (8’’)50 mm voice coil (2”) 8 x 25 mm (1”) custom neodymium compression drivers and 44 mm voice coil (1.7”) 8 polypropylene waveguide horns with 90° horizontal dispersion 15° vertical dispersion On-board presets allow different equalization configurations, gain and digital delay through the rear control panel Specifications Configuration way: 2 Built-in amplifiers LF/HF (Wrms): 1400/700 Frequency response (-6dB): 58Hz – 18kHz Low frequency woofer (inch): 8 x 8 – 2 coil – neodymium High frequency driver (inch): 8 x 1 – 1,7 coil – neodymium Sensitivity (1W/1m): 105 dB Maximum SPL: 137 dB Dispersion (H x V): 90° x 15° Input impedance (kohm): 22 Crossover frequency (kHz): 1,2 AC Power requirements (VA): 1400 Input connectors: XLR with loop Power cord: 5 / 16,4” (m/ft) Net dimensions (WxHxD – single unit): 713x980x460 / 28,1×38,6×19,3 (mm / inch) Net weight (kg/Lb): 93 / 205,02 Transport dimensions (WxHxD – 2 units on pallet): 750x1400x1100 / 29,5×55,1×43,3 (mm / inch) Transport weight (2 units on pallet): 210 / 462,97 (kg/Lb) PRODOTTO USATO: CONDIZIONI OTTIME

Marchio: Audiophony Categoria: Casse da installazione Max powers: 7,5 / 15 / 30 / 60 W Systems: 100 V 8 ohm Drivers: 6,5" + 1"" Sensitivity (1W/1m): 90dB, +/-3 dB Frequency response: 70 - 20,000 Hz Material: Plastic enclosure and aluminium grille Holding:Wallmount bracket Connectors:Waterproof cable on gland IP55 Power rotary knob: 60 W 8b'&'ohm; // 7,5 / 15 / 30 / 60 W 100V Dimensions (WxDxH): 214x178x329mm Weight: 4,7 kg

Marchio: Audiophony Categoria: Casse da installazione Power: 300 W RMS – 600 W max. @ 8 ohms 50/100/200 W @ 100 V Woofer: 12" membrane 3" coil Tweeter: 1 x 1.7" coil Dispersion: 80° x 80° (HxV) Frequency response: 55 – 18,000 Hz SPL: 123 dB continuous, 129 dB max. / 8 ohms Connectors: Internal terminal block with cable glands Aluminum grill, stainless steel screws Dimensions: 407 x 410 x 448 mm Net weight: 20 kg

Marchio: Audiophony Categoria: Casse da installazione Max power: 20 or 40 or 80 W at 100V; 10 or 20 or 40 W at 70V; 50 W into 8 ohm Power supply: 100V/ 70 V or 8 ohm Impedances: 125 or 250 or 500ohm; or 8 ohm low impedance Speakers: 8" Woofer and 1" tweeter Sensitivity (1 M/1W): 92 dB Frequency response: 70 Hz-18 kHz Material: ABS enclosure, steel grill Holding system: Adjustable holding bracket Connectors: 2-pin connector Dimensions: 302x172x165 mm Weight: 3.4 kg

Marchio: Audiophony Categoria: Casse da installazione Max powers: 15 / 30 W Systems: 100 V 16ohm Drivers: 5" + 1" Sensitivity (1W/1m): 88dB, +/-3 dB Frequency response: 60 - 20,000 Hz Material: Plastic enclosure and aluminium grille Holding:Wallmount bracket Connectors:Waterproof cable on gland IP55 Power rotary knob: 30 W 16b'&'ohm; // 15 / 30 W 100V Dimensions (WxDxH): 178x236x255 mm Weight: 2,38 kg

Marchio: Audiophony Categoria: Casse da installazione Power: 60 W RMS – 120 W max. @ 8 ohms – 5/10/20/40 W @ 100 V by selector Woofer: 6.5" graphite 1" silk dome tweeter Rear bass reinforcement membrane Frequency response: 90 – 20,000 Hz SPL (@ 1m) 102 dB max. Dispersion: 90×80° HxV Connectors: Euroblock ABS construction Dimensions: 285 x 200 x 195 mm Net weight: 3.5 kg

Marchio: Audiophony Categoria: Casse da Installazione Plywood enclosureWith a monitor-specific angle Finishing: Black granite epoxy paint; Integral steel grill protection; 1 cut-away handle Frequency response (-3 dB): 80 Hz - 19 kHz Max power: 150 W RMS / 300 W peak Impedance: 8 ohm Sensitivity 1 W/1 m: 94 dB / 121 dB peak Boomer: 8" die cast aluminium frameWith 50 mmVoiceVoice coil Ø HF driver: 1" driverWith 44 mmVoiceVoice coil Ø Dispersion(HxV): H 50 or 100°,V 55° Internal passive filter: cut-off frequency 2100 Hz Connectors: speakON x 2 (1+1- full range) Mounting socket for spacer pole Dimensions (L x W x H): 280 x 420 x 233 mm NetWeight: 10 kg